Gaggenau DF461, Руководство по эксплуатации

Страница: 11 / 23

11
Note
Even if the rinse aid and/or salt refill indicator is lit, the
rinse programme runs correctly when 3in1 products are
used.
If the rinse aid refill indicator
6
or salt refill
5
indicator is defective and you would like to switch it off,
proceed as follows:
Switching the rinse aid refill indicator
off and on
Hold down the programme button
3
and press the
main switch
1
until the digital display lights up,
then release the buttons.
4
is indicated on the
digital display .
Each time the button
3
is pressed, the set value
increases by one; when the value is reached, the
display jumps back to . To switch off, select the
position.
Switch off the main switch
1
; the setting is saved.
Switching the salt refill indicator /
water softening system off and on
Hold down the programme button
B
and switch on
the main switch
1
, then release the buttons.
The illuminated button
B
and the factory-set value
on the digital display flash.
To change the setting: press the programme button
B
.
Each time the button is pressed, the set value
increases by one; when the value
is reached, the
display jumps back to (the salt refill indicator /
water softening system has been switched off).
Switch off the main switch
1
. The set value is
stored within the device.
Approx. 4 litres of water are required to regenerate the
water softening system. As a result, the water
consumption per rinse cycle increases by 0 to
maximum 4 litres depending on the water hardness
setting.
Note
If you use the detergent and rinse aid separately or
switch from combined detergents to standard cleaning
products, ensure that the rinse aid refill indicator has
been switched on and the water softening system has
been set to the correct water hardness.