26
Fault, what to do?
Utensils not dry.
No or too little rinse aid
in the dispenser.
Refill rinse aid.
Programme selected without drying.
Select programme with drying (see Overview
of programmes, Programme sequence).
Water collecting in depressions on
the utensils and cutlery.
Arrange utensils in a sloping position, arrange
affected utensils as sloping as possible.
The combined detergent used has
a poor drying performance.
Use different combination detergent with bet-
ter drying performance. Use of rinse aid also
increases the drying performance.
Intensive drying to increase drying not
activated.
Activate intensive drying (see Operating
the appliance)
Utensils were removed too early or dry-
ing process had not ended yet.
Wait until program ends or wait until 30 min
after program ends before removing utensils.
The eco rinse aid used has a poor dry-
ing performance.
Use a proprietary rinse aid. Eco products are
much less effective.
Plastic utensils not dry.
Special properties of plastic.
Plastic has a lower heat storage capacity and
therefore dries less well.
Cutlery not dry.
Cutlery not arranged properly
in the cutlery basket.
Separate cutlery if possible, prevent contact
points.
Cutlery not arranged properly
in the cutlery drawer.
Arrange cutlery properly and separate if possi-
ble.
Appliance interior wet after rinse
cycle.
No appliance fault.
On account of the “Condensation drying” prin-
ciple, water droplets are physically induced
and required in the container. The humidity
in the air condenses on the inner walls
of the dishwasher, drains and is pumped out.
Food remnants on the utensils.
Utensils placed too closely together,
utensils basket overfilled.
Arrange utensils with adequate clearance
between them ensuring that the spray jets can
reach the surface of the utensils. Prevent con-
tact points.
Spray arm rotation obstructed.
Arrange utensils so that the spray arm can
rotate without obstruction.
Spray arm nozzles blocked.
Clean the spray arm nozzles,
(See Cleaning and maintenance).
Filters
1Z
dirty.
Clean filters, (see Cleaning and maintenance).
Filters
1Z
inserted incorrectly and/or
not engaged.
Insert and engage filters correctly.
Rinse programme too weak.
Select a more intensive rinse programme.
Utensils precleaned too intensely; sen-
sors therefore decide on weak pro-
gramme sequence. Stubborn soiling
cannot be completely removed.
Do not prerinse utensils. Remove only large
food remnants.
Recommended programme Eco 50° or Inten-
sive.
Tall narrow receptacles in corner areas
are not rinsed adequately.
Do not place hollow receptacles too obliquely
and do not place in the corner area.
Top basket
1*
on right and left not
set to same height.
Set top basket to same height using side
levers.
Fault
Cause
Remedial action
Содержание DF260161
Страница 1: ...DJJHQDX 2SHUDWLQJ LQVWUXFWLRQV LVKZDVKHU DF260161 DF261161...
Страница 2: ...K 6WDUW K K PLQ 5HVHW VHF...
