Gaggenau DF211100, Инструкция по применению

Страница: 53 / 64

Troubleshooting
en
53
Fault Cause and troubleshooting
Refill indicator for spe-
cial salt does not light
up. Water softening system is switched off.
▶
Set the water softening system.
→
"Setting the water softening system", Page 25
Refill indicator for
rinse aid lights up. Insufficient rinse aid.
1.
Add Rinse aid → Page 27 .
2.
Set the amount of rinse aid to be dispensed.
→
"Setting the amount of rinse aid", Page 27
Refill indicator for
rinse aid does not
light up. Rinse aid system is switched off.
▶
Set the amount of rinse aid to be dispensed.
→
"Setting the amount of rinse aid", Page 27
Water is left in the ap-
pliance at the end of
the programme. Filter system or area under the filters is blocked.
1.
Clean the Filters → Page 40 .
2.
Clean the Wastewater pump → Page 56 .
Programme has not yet ended.
▶
Wait until the programme ends or cancel the pro-
gramme with
Reset
.
▶
→ "Terminate programme", Page 34
Appliance cannot be
switched on or oper-
ated. Software update is taking place.
▶
Wait until the software update has finished.
Appliance functions have failed.
1.
Pull out the mains plug or switch off the fuse.
2.
Wait at least 2 minutes.
3.
Connect the appliance to the power supply.
4.
Switch the appliance on.
Appliance does not
start. The mains fuse has tripped.
▶
Check the relevant fuse.
Mains cable is not inserted.
1.
Check whether the socket works.
2.
Check whether the mains cable is properly inserted
in the socket and on the rear of the appliance.
Appliance door is not closed properly.
▶
Close the appliance door.
Programme starts
automatically. You did not wait until programme ended.
▶
→ "Terminate programme", Page 34
Appliance stops dur-
ing the programme or
cuts out. Appliance door is not closed properly.
▶
Close the appliance door.
Power and/or water supply has been interrupted.
1.
Check the power supply.
2.
Check the water supply.