Gaggenau CV 281, Инструкция по эксплуатации

Страница: 25 / 36

25
Power manager
en
Suitability test of tableware
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1 Correctly position the pot with approximately
200
ml of water, at room temperature, on the most
suitable cooking zone for the diameter of the
bottom of the pot.
2 Go to the basic settings and select the
setting
™‚ ƒ
.
3 Press the programming area.
A
flashes in the
cooking zone displays.
The function has now been activated.
After 10 seconds, the cooking result and the speed of
the cooking process appear in the visual displays for the
cooking zone.
Check the result using the following table:
To reactivate this function, touch the settings range.
Notes
– If the diameter of the hotplate used is much smaller
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
– You can find information on this function in the
section on
~
"Basic settings"
.
– You can find information on the type, size and
positioning of the cookware in the section on
~
"Induction cooking"
.
h
Power manager
Power manager
You can use the power manager to set the total power of
the hob.
The hob is preset at the factory. Its maximum
performance is specified on the rating plate. You can
use the power manager to change the value in
accordance with the requirements for the relevant
electrical installation.
In order not to exceed this set value, the hob
automatically distributes the power available between
the cooking zones that are switched on.
As long as the power manager function is activated, the
output of a cooking zone may temporarily fall below the
nominal value. If a cooking zone is switched on and the
power limit is reached,
¬
appears in the heat setting
display for a short time. The appliance automatically
regulates and selects the highest possible power level.
For more information about how the total power of the
hob is changed, see section
~
"Basic settings"
Result
‹
The cookware is not suitable for the hotplate and will
therefore not heat up.*
‚
The cookware is taking longer to heat up than expected
and the cooking process is not going as well as it
should.*
ƒ
The cookware is heating up correctly and the cooking
process is going well.
* If there is a smaller hotplate available, test the cookware
again on the smaller hotplate.
PLQ