5
control. Fig. 1.
Gas burners
To switch on the burner, press the appropriate burner
All of the operating controls show which burner they
keep the control pressed for longer this time (up to a
Sparks are produced in this control position in all burners.
maximum of 10 seconds).
need to press the control).
If the ignition sparkers are dirty, this makes the burner harder
If the burner does not ignite, repeat the procedure and
it pressed in this position until the burner flame is lit.
Turn the control to the desired position (you no longer
feature, use a lighter or a match to light the burner.
to light, so you should keep them as clean as possible. Clean
To
turn on and activate
t
his innovative system, proceed in
the same way, but keep the control pressed down until it comes
them using a small brush, and remember that the ignition
If your cooking hob is not fitted with this automatic lighting
sparkers must be treated very gently.
Your hob may be fitted with
safety thermocouples
which
completely normal.
turned off. Fig. 2.
on, with the flame appearing and staying lit.
prevent gas from being released if the burners are accidentally
the desired heat.
hold the knob pressed in for 1-5 seconds.
The large double flame burner is highly practical and suitable
for cooking with paella pans, woks, etc.
The modern functional cooking hob you have purchased has
When you are using this gas appliance, it will make the kitchen
is well ventilated. Keep all the natural sources of ventilation
If your hob has a large double flame burner, it will have a tap
open, or install a mechanical ventilation device (such as an
require supplementary ventilation, such as an open window
from a wide range of powers. Operating description Fig. 3.
(while avoiding draughts) or you may need to increase the
power of any mechanical system.
fitting that will enable you to control the inner and outer flames
When being used for the first few times, it may produce a
slight smell.
hot and humid, and therefore you must ensure that the kitchen
An orange-coloured flame is normal and it is produced in
separately. This revolutionary system allows you to choose
extractor fan). If your appliance is in continual use, you may
the presence of dust in the atmosphere, spillages, etc.
Fig. 1
Sparker
Both rings (inner and outer) burn at full power.
The outer ring burns at minimum power, the
inner ring burns at full power.
The inner ring burns at full power, the outer
ring is turned off.
The inner ring burns at minimum power, the
outer ring is turned off.
control and turn it to the left to the highest position; keep
progressive taps fitted which allow you to
adj ust the flame
to
To turn it off,
turn the control to the right to the position
0.
If the burner does not light, repeat the procedure but this time
When doing this, the ignition system may work again
- this is
Fig. 2
Fig. 3
Thermoelectric
safety pilot
