
en
Installation instructions
62
2.
Remove the cover cap.
3.
Undo the two screws a little, but do not completely
remove them.
4.
Adjust the appliance door using the side screw; to
do this, open the appliance door and then close it
again if necessary.
5.
Check the alignment.
6.
Tighten both screws.
5
7.
Fit the cover cap.
8.
Slide the appliance into the built-in recess.
22.12 Combining the appliance with an oven
1.
Only combine suitable appliances of the same
brand and series.
2.
Fit the combi-steam oven first, then the oven.
3.
Note the installation instructions for the oven.
4.
For an installation depth of 550 mm, position the
water hoses and the connection cable in the area of
the slanted edge on the corner of the housing.
5. Note:
The rear side of BO 4.. ovens has a sloped
corner.
Run the inlet and outlet hose for the combi-steam
oven downwards to the connections in the rear left
of the installation cabinet.
6.
If the hoses are not kept in the rear-left corner of the
installation cabinet, the cabinet body must be pulled
forwards by at least 35 mm, and side panels or fa-
cing must be used when installing the appliance
above an oven.
22.13 Combining the appliance with a
warming drawer (60 cm)
ATTENTION!
Sharp edges on the appliance may damage the panel
of the warming drawer.
▶
Do not damage the warming drawer cover when
sliding the appliance in.
1.
Only combine suitable appliances of the same
brand and series.
2.
Install the warming drawer first.
3.
Follow the installation instructions for the warming
drawer.
4.
Slide the appliance, on the warming drawer, into the
built-in cabinet.