GADLEE GT 55, Руководство оператора

Страница: 25 / 60

For an effective cleaning and long life of the equipment, it is necessary to follow some
simple rules:
•
Prepare the work area, keeping away the possible obstacles;
•
Begin to work starting from the farthest spot, in order to avoid trampling on the area
just-cleaned;
•
Choose paths that are as much straight as possible;
•
On wide floors divide the paths into rectangular and parallel areas.
At the end quickly mop the area, if necessary, to clean spots that are inaccessible to the
scrubber.
6.7 Work
After setting up the machine, proceed as follows:
•
Connect the machine to the power supply:
- cable model: plug the machine into the mains power socket;
•
Insert and operate the key and switch to the “on” postion(fig. 6, ref. 1, B and C model)
or insert and operate the key to release the emergency button (fig. 6, ref. 1, BT model
only), and make all the machine functions active: the power supply led lights up (fig. 6,
ref. 2);
•
Move the tap lever (fig. 6, ref. 7) to the position of minimum flow of solution: the
detergent solution begins to reach the brush;
•
Lower the squeegee by means of the proper lever (fig. 7, ref. 5);
•
Versions with mechanical drive: press the brush switch (fig. 6, ref. 3) and led on, to
enable the function “brush”;
•
Versions with electric drive: press the brush switch (fig. 6, ref. 3) and led on, to
enable the function “brush”;
•
Press brush/drive control lever (fig. 6, ref. 8);
•
Versions with mechanical drive: when the brush switch is on and the drive lever is
pulled, the motor which turns the brush and moves the machine starts up. A special
mechanical drive device uses the friction between the brush and floor to generate a
forward movement. When the mechanical drive lever is released, the brush motor
shuts down and the machine stops.
If the machine pulls to one side, restore a straight course by using the direction regulation
knob (fig. 4, ref. 2 ). If the machine pulls to the right, turn the knob clockwise and vice
versa.
•
Models with electric drive: to move forwards or backwards, see paragraph 6.3.
In both versions:
•
Periodically check that the detergent solution reaches the brushes and refill when
finished; when water in the solution tank is no longer sufficient, the level indicator will
come on (fig. 6, ref. 4): stop and fill the tank;
•
During work check the cleaning quality and adjust the solution flow sent to the brushes
by raising or lowering the lever (fig. 6, ref. 7) as required.
* WARNING
Never leave the machine stationary with the head lowered and the brushes in
motion: the floor could be damaged.
* WARNING
Whenever you fill up the solution tank, always empty the recovery tank.
Do not leave the machine stationary with the suction motor on and the solution
cock turned on.
•
If the recovery tank is full, the level indicator will come on (fig. 6, ref 5) and after a few
seconds the suction motor will lock out: stop and empty the tank; to re-start the suction
ENGLISH
15