GADLEE GT 25 Series, Руководство оператора

Страница: 28 / 56

ENGLISH
16
6.10 Draining off clean water
!
DANGER
Use suitable personal protection devices. Drain the water with the machine
disconnected from the power supply.
To empty the tank:
• Take the machine next to a drain;
•
T
ake off the drain cock (fig. G, ref. 1)
• When the contents have been totally drained from the solution tank, close the cap (fig.
G, ref. 1); check that it is perfectly closed.
i INFORMATION
The water and detergent solution can also be used to wash the recovery tank.
7.
PERIODS OF INACTIVITY
If the machine is to remain unused for a long time, the squeegee and brushes (or drive
discs or rollers) must be dismounted, washed and kept in a dry place (preferably packed
in a plastic envelope or sheet), sheltered from dust. Park the machine with the small
carriage in the raised position.
Furthermore, make sure that the tanks are completely empty and perfectly clean.
Disconnect the machine from the power supply (depending on the model: unplug the
machine from the mains or disconnect the ANDERSON connector from the battery wiring).
Models with battery: recharge the batteries completely before putting them in the
storehouse. During long periods of inactivity recharge the batteries (once every two
months at least) to preserve the storage batteries constantly at the maximum charge.

IMPORTANT
If the batteries are not recharged periodically, they may become damaged
irreparably.
8.
MAINTENANCE AND BATTERY RECHARGING
!
DANGER
Do not check the battery charge by producing sparks.
The batteries give off inflammable vapours: put out any fire or embers before
checking and filling up the batteries.
Perform the operations described below in airy environments.
To avoid permanent damages to the batteries, never let them get flat completely.
Remember that when the proper red led (fig. C, ref. 2) flashes on the control panel, it is
necessary to recharge the batteries.
8.1 Recharging procedures
• If the machine does not have an on-board charger, connect the external battery
charger connector to the battery wiring connector.
• If the machine has an on-board battery charger, connect the on-board battery
charger power cable (fig. H, ref. 1).

IMPORTANT
During recharging do not let the temperature of the electrolyte exceed 45°C.