GADLEE GT 25 Series, Руководство оператора

Страница: 21 / 56

ENGLISH
9
accepting the goods, reserve by written the right to present a claim for the refund of the
damages.
5.3 Unpacking

IMPORTANT
On unpacking the machine, the operator must be provided with the necessary
accessories (e.g. gloves, protective goggles etc.) to limit possible hazards of
accidents.
Unpack the machine in the following way:
• Cut and remove the plastic straps with scissors or nippers;
• Remove the packaging;
• Remove the bags included in the packaging and check the contents:
- guarantee slip;
- use and maintenance manual;
- battery bridges with terminals (battery model only);
• Depending on the model, remove the metal brackets or cut the plastic straps, which
fix the machine chassis to the pallet;
• Let the machine slide down the pallet on an inclined plane, by pushing it into reverse;
• Clean the outside of the machine observing the safety rules;
• After unpacking the machine, you can install the batteries (models with battery) or
perform the electric connections (models with cable): see respective paragraphs.
If necessary, preserve the wrapping material as it could be used again to protect the
machine in the event of a move or if the machine should be sent to a service centre for
repair.
Otherwise, the material must be disposed of in compliance with the laws in force.
5.4 Electric connections and grounding (models with cable)
On the identification plate the electric characteristics of the machine are written: make
sure that the frequency and line tension are the same of those of the environment where
you are going to work.
As far as voltage is concerned, the models showing a voltage of 230 V on the plate can
be used for voltages ranging from 220 to 240 V. The same is true for the models showing
a voltage value of 115 V, which can be used for voltages ranging from 110 to 120 V. The
frequency indicated on the plate must always correspond to that of the mains.

IMPORTANT
Make sure the mains circuit is suitably earthed and that the sockets (and any
adaptors used) ensure the continuity of the earth conductors.
! DANGER
Failure to observe these instructions could cause possibly serious damage to
people and things and invalidates the guarantee.
5.5 Feeding batteries
Two different batteries can be fitted on this machine:
•
Tubular leak-proof batteries
: these batteries require the periodical check of the
electrolyte level. When it is necessary, top up with distilled water alone until the plates
are covered; do not overfill (max. 5 mm. above the plates).
•
Gel batteries
: this kind of batteries requires no maintenance.