G21 Razor, Руководство пользователя

Страница: 11 / 72

Wire the unit.
Embed the switchbox in the installation location
and wire the power cord (with the green and yellow
combined is ground line).
• If no switchbox is used, the power cord will
be pushed out, and prevent the unit from being
installed firmly against the wall.
Attach the installation panel to the wall using the
6 installation screws.
If the wall is concrete, use commercially available
metal screw plugs.
If the wall is not concrete, reinforce it before
installation.
Remove the drain tank. Remove the front panel. Remove the terminal box
cover.
Pull the separate line power cord into the unit
and secure inside.
Pull the power cord through the power cord hole on
the rear of the unit, attach the rear side to the 3 hooks
on the installation panel and secure with the installation
screws while pushing the unit against the wall lightly.
The installation screws for the unit will not tighten
completely if the hooks at the bottom of the installa-
tion panel are not in place. Ensure the lower hooks
are completely hooked onto the rear of the unit.
Installation procedures
Connecting the appliance can either install it to the terminal, or by using the power cable.
Use a multiplied wire power cord which is 1.5mm
2
- 2.0 mm
2
multiplied wire (cords other than
1.5mm 2 - 2.0 mm 2 single-core cords cannot be used.)
(A drop in voltage is possible if the power cord exceeds 11 m in length.)
Before installation the product please remove the test line (cable with plug).
1
2
3
4
Note:
Ensure the unit is hooked on the installation panel, tightened the fixed screws, otherwise, this
may cause the unit to drop and be in the danger of theft.
• Remove the two screws.
• Remove all the front
panel chuckholes.
• Remove the terminal
box cover screw and pull
the cover out towards you.