Dump Mode
Page 10
Empty the Spreader using DUMP MODE.
1. Goto DUMP mode.
2. Quick press the power button to enter DUMP mode.
3. Quick press the
6
button will put the spreader in to EMPTY mode. In this mode the EMPTY label will
flash.
- Hold down the
5
or
6
buttons to make the chain start.
- The Monitor will run the Chains until the user quick presses the power button. Or the chain motors are
stopped. Stop the chain motors by holding down the
5
or
6
buttons.
Chain RPM during DUMP MODE. Hold the
5
or
6
buttons to achieve the desired RPM.
Speed of the Spinner in DUMP MODE. In a Twin floor system, this is under Mechanical
control. In Single floor mode the DUMP RPM is set in the SETUP Screens.
Weight out put by Spreader as calculated by the monitor, based
on internal settings and Material density and door opening.
The Chain RPM and rotations of the Chain motors are counted.
EMPTY flashes when in EMPTY mode.
