G.T.Power A8, Руководство по эксплуатации

Страница: 15 / 23

-
13
-
7. NiMH/NiCd battery program
These programs are for charging or discharging NiMH (Nickel-Metal-Hydride) or
NiCd (Nickel-Cadmium) battery commonly used for R/C model aplications. To alter
the value at the display, press
Start/Enter key to make it blink then change the value
using INC or DEC key.The value will be stored by pressing Start/Enter key once.
To start the process, press Start/ Enter button for more than 3 seconds.
7.1 Charging NiCd/NiMH battery
This program simply charge the battery using the
current you set. In 'Aut' mode, you need to set the
upper limit of charge current to avoid from higher
feeding current that may damage the battery. Because
some batteries of low impedance and small capacity
can lead to the higher charge current by the processor
at automatic charge mode. But in 'Man' mode, it will
charge the battery with the charge current you set at
the display. Each mode can be switched by pressing
INC and DEC button simultaneously when the current
field is blinking.
The screen displays the current state of charging . To
stop the process, press
Batt type/Stop key once.
The audible sound indicates you the end of process.
7.2 Discharging NiCd/NiMH battery
Set discharge current on the left and final voltage on
the right. The discharge current ranges from 0.1 to
5.0A and the final voltage ranges from 0.1 to 30.0V). To
start the process, press Start /Enter key more than 3
seconds.
The screen displays the current state of discharge. You
can alter the discharge current by pressing Start/Enter
key during the process. Once you change the current
value, store it by pressing
Start/Enter button again.
To stop discharging press Batt type/Stop key once.
The audible sound indicated you at the end of process.