Activating the Alarm
Once the alarm is armed via text or keyfob, the alarm is then ready and sensing all paired
beams.
When a sensor is broken this will trigger the siren for the pre determined length of time and
also send a text message to two pre programmed phone numbers. It will also call you if
you have set up the call on feature (please see page 4)
The text message will relate to which sensor has been broken - you can pair upto 20
sensors and name them individually. T o individually name each sensor please see page 4
- the default texts are IR01, IR02 etc
Once the alarm has been activated, it will automatically re-arm once the beam has been
cleared.
Disabling Sensor 1 Only
If you want to remove sensor 1 from operation you send the text command
#
BEAM1
=
ON
#
This will re-enable sensor 1
#
BEAM1
=
OFF
#
This will disable sensor 1
The purpose of this function is to deactivate one sensor whilst retaining the rest of the
alarm system. This could be for a constantly used door during day time hours.
www.gsm-activate.co.uk
- 01273462380 - [email protected]
Page 7
Factory Reset
To reset the unit back to factory settings you will need to send the text message
#
RESET
#
PLEASE NOTE
- By doing this you will reset ALL of your parameters. ONLY send this
seset command when necessary.
The
GREEN
ready LED will flash eight times.
