OPERATION
●
After you connected the effect to the mains, this moving-head light starts running. During the
reset, the motors are trimmed and the device is ready for use afterwards.
●
You can control the projectors individually via you DMX-controller, Every DMX-channel has a
different occupation with different features, in order to all up the different features. You first
have to open the shutter.
●
Turn the focus-screw next to the objective-lens for adjusting the focus in order to obtain a sharp
projection.
Connection:
●
After finished all mentioned process, confirm fixed the right lamp, turn on the switch and check
if everything is correct, connect the light with power supply, after some seconds will start.
Reposition, at the same time, if everything is ok, LCD screen will display DMX start ADD No (run
node: DMX512- DMX001.
DIMMER:
●
Turn on the lamp controller and use cross screw-driver adjust the three screw which located at
the back of light, adjust the three screw, and turn to best brightness.
