Rigging
DANGER TO LIFE!
Please consider the respective national norms during the installation!
The installation must only be carried out by an authorized dealer!
●
The installation of the projector has to be built and constructed in a way that it can hold 10
times the weight for 1 hour without any harming deformation.
●
The installation must always be secured with a secondary safety attachment, this secondary
safety attachment must be constructed in a way that no part of the installation can fall down if
the main attachment fails.
●
When rigging servicing the fixture staying in the area below the area below the installation
place. On bridges, under high working places and other endangered areas is forbidden.
●
The operator has to make sure that safety-relating and machine-technical installations are
approved by an expert before taking into operation for the first time and after changes before
taking into operation another time.
●
The operator has make sure that safety-relating and machine-technical installations are
approved by expert after four year in the course of an acceptance test.
●
The operator has make sure that safety-relating and machine-technical installations are
approved by a skilled person once a year.
Procedure:
●
The projector should be installed outside areas where persons may walk by or be seated.
●
Important! Overhead rigging requires extensive experience. Including (but not limited to)
calculating working load limited, installation material being used, and periodic safety inspection
of all installation material and the projector. If you lack these qualifications, do not attempt the
installation yourself, but instead use a professional structural rigger. Improper installation can
result in bodily injury and or damage the property.
●
The projector has to be installed out of the reach of people.
If the projector shall be lower from the ceiling or high joists, professional trussing systems have
to be used, the projector must never be fixed swinging freely in the room.
Caution: Projectors may cause severe injuries when crashing down!
●
If you have doubts concerning the safety of a possible installation, do not install the projector!
●
Before rigging make sure that the installation area can hold a minimum point load of 10 times
the projector’s weight.
DANGER TO LIFE!
When installing the device, make sure there is no highly-inflammable material (decoration articles,
etc,) within a distance of min 0.5m.
CAUTION!
Use 2 appropriate clamps to rig the fixture on the truss.
Follow the instructions mentioned at the bottom of the base.
Make sure that the device is fixed properly! Ensure that the structure (truss) to which you are
attaching is secure.
●
The moving head can be placed directly on the stage floor or rigged in any orientation on a truss
without altering its operation characteristics.
