INSTALLATION
Installing / replacing the lamp
DANGER TO LIFE
Only install the lamp with the device switched off! Unplug from mains before!
For the installation, you need one 189W fast fit lamp
Protection gloves, helmet with sight, leather apron.
CAUTION!
The lamp has to be replaced when it is damage or deformed due to the heat!
●
The lamp life given by the manufacturer must never be exceeded, this is why you need to take
note on the operational time of the lamp and replace the lamp in time.
●
Keep exchanged lamp in a protective container and remove accordingly.
●
During the operation, the lamp reaches temperatures of up to 600
°
C
●
Before replacing the lamp unplug mains lead and let the lamp cool down (appr 10 min)
●
During the installation do not touch the glass- bulbs bare-handed! Please follow the lamp
manufacturer’s notes!
●
Do not install lamps with a higher wattage! Higher wattage lamp generate temperatures, the
device was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1: unscrew the fixation screws of the lamp cover and remove it.
Step 2: unscrew the knurled-head screws of the lamp holder and remove it.
Step 3: if replacing the lamp, remove the old lamp from the lamp holder.
Step 4: insert the lamp into the lamp holder.
Step 5: replace the lamp holder and tighten the knurled-head screws.
Step 6: adjust the lamp as described under lamp adjustment.
Step 7: replace the lamp cover and tighten the fixation screws.
Do not operate the device with opened cover!
Lamp adjustment
●
The lamp holder is aligned at the factory, due to differences between lamps, fine adjustment
may improve light performance.
●
Strike the lamp, open the shutter and the iris, set the dimmer intensity onto 100% and focus the
light on flat surface(wall), center the hot-spot(the brightest part of the beam) using the 3
adjustment screw turn one screw at a time to drag the hot spot, adjust the lamp until the light is
even.
●
To reduce a hot-spot, pull the lamp in by turning all three screws, clockwise 1/4 turn, at a time
until the light is evenly distributed.
●
If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is
too far back in the reflector, push the lamp out by turning the screw counter clockwise 1/4 turn
at a time the light is bright and evenly distributed.
