G.I.KRAFT GI12117, Руководство пользователя

Страница: 19 / 19

2 、 Troubleshooting
Reason Remedy
No weld output
(1)Connected power supply
incorrectly.
(2)Power switch in off
position
（
1
）
Connect power supply according
to manufacturer’s
ins
tructions.
（
2
）
P
lace power s
w
itch in “on”
position.
Trigger not working
（
1
）
Trigger damaged.
（
2
） G
un control wire broken.
（
3
）
Co
ntrol wire plug loosen.
(4)Mode switch in incorrect
position.
（
1
）
Replace trigger.
（
2
）
Connect again or replace if nec-
essary.
(3)Connect control wire plug again.
(4)Place Mode switch in correct pos-
ition.
(1)Aamperage too low
(2)Weld time too short.
(3)Input power cord did not
meet the requirement.
(4)Ground clamp bad contact.
(
1)
Increase amperage setting
(2)Increase time setting.
(3)Replace input power cord.
(4)
C
hange ground clamp location.
Piercing workpiece
(1 ) Output amperage too high.
(2)Weld time too long.
(3) Bad contact of electrode tip or
washer with workpiece.
(1)Reduce amperage setting.
(2)Rrduce weld time.
(3)Remove coating from material
reduce added pressure.
Kriptol working
unstable
(1)Kriptol did not polish,workpieces
did not polish.
(2)
I
ncorrect amperage and time
setting.
(1 ) Polish kriptol and workpieces
(2)
S
et amperage and time according to
workpiece thickness.
Unit stop working
while operation
(1)Trigger plug loosen.
(2)Gun control wire broken.
(3)Over heating. (1)Check gun control wire and
trigger plug.
(2)Wait for temperature cool down.
Maintenance
Trouble
Poor weld
.
.
Page.17