© 2012 G Force Automatic Gates All Rights Reserved
Mounting the Gate Motor
The gate motor should be mounted on a solid post or pillar about 50mm — 100mm from the gate
hinges and the motor shaft should be approximately at the same level as the bottom rail of the
gate
Place the complete motor on a work bench. Remove the black steel motor cover. Take note or a
photo detailing how the gate motor is assembled and the circuit board wiring for possible future
reference.
Separate the drive assembly and circuit board from the gate motor mounting cradle by
undoing the 4 nuts underneath the motor holding the drive assembly in the mounting cradle and
remove the drive assembly and circuit board from the gate motor mounting cradle. Take care not
to damage the circuit board or allow it to get wet.
AG5 DC2 GATE MOTOR
INSTALLATION AND SET UP
INSTRUCTIONS
Complete
Motor
Assembly
without cover
Undo the 4
nuts
underneath
the motor.
Mounting Cradle
Drive Assembly
with Circuit Board
Mounting Cradle
Motor Cover
Drive Arm
Undo 4 nuts
underneath gate
motor to remove
Motor assembly
.
Ensure the lip
of the motor
cover correctly
fitted over the
mounting cradle
.
4 Spacer
Tabs
.
Check the 4 spacer tabs are in place on the back of the mounting cradle. If the spacer tab has fallen off
then attach it with silicon otherwise use packing washers to replace the spacer tab. The spacer tabs allow
the lip of the motor cover to be correctly fitted over the mounting cradle.
