FUXTEC FX-AF1139, Оригинальное руководство пользователя, Страница: 16 / 22

Original User Manual FX-AF1139_rev03
16
device.
Clean the milling area:
-
Switch off the engine and let it cool down.
-
Remove dirt and brush off residues with a scraper
and brush.
-
After you have removed the residues, you can use a
water jet for a more thorough cleaning.
-
Direct the water jet onto the milling tools. Never
point the jet at the gear or engine. If water gets into
the ignition system or the carburettor, damage and
defects will occur.
-
If you have used water for cleaning, the engine will
get wet unintentionally. Start the engine and let it run
for a few minutes until the engine's heat evaporates
the remaining water in the engine's area.
Other areas:
Clean the rest of the device with a cloth moistened with
water. Never use gasoline, solvents, detergents, water,
or other liquids.
8.1.3.
CHECKING THE OIL LEVEL
-
Place the device on a horizontal, clear, level surface.
-
Unscrew the cover of the oil filler neck.
-
Clean the oil dipstick with a cloth.
-
Insert the dipstick and unscrew the oil filler cap.
-
Unscrew the plug and check the mark left by the oil on
the dipstick. The mark left by the oil must be between
the minimum and maximum mark.
-
If the mark is below the minimum, add a little more oil
and check again.
-
If the mark is above the maximum, you must remove
the engine housing oil. To do this, tilt the device and
drain some oil (place a container at the end of the pipe
so that no oil from the device reaches the floor).
8.2. REGULAR MAINTENANCE
Perform regular inspections of the device to ensure the
device's effective operation and avoid the risk of
damage to the device and injury to the user. Spare
parts should be purchased from the official service
dealer.
Other spare parts can lead to the risk of accidents,
injury to the user, and damage to the device.
Perform maintenance frequently, as indicated in the
following table:
Action
B
e
fo
re
e
a
ch
u
se
A
ft
er
t
h
e
fir
st
2
H
o
ur
s
o
f u
se
E
ve
ry
2
5
o
p
er
at
in
g
ho
ur
s
E
ve
ry
5
0
o
p
er
at
in
g
ho
ur
s
T
h
e
fir
st
u
se
o
f t
h
e
se
as
on
A
ft
er
t
h
e
la
st
u
se
o
f
th
e
se
a
so
n
Check the device for loose parts -•
Check the status of the milling tool -•
Check the oil level -•
Change the engine oil -• -• -•
Clean the air filter -•
Check the spark plug -• -•