00078079.DOC, Version 1.0
41/55
Wireless receiver transmitter status LED
Red permanently lit: not logged into a wireless transmitter (free).
Red/green flashes rapidly: Login-mode, the wireless receiver is logging into the wireless transmitter.
Green permanently lit: The wireless receiver is logged into the wireless transmitter. The DMX signal is
present and received.
Red/green flashes slowly: no DMX-signal, the radio link is being held.
The installation procedure of a wireless DMX system depends on the wireless sender. Please refer to
the user manual of the respective device.
Log out one wireless receiver
The projector is logged out via the Control Board, menu Personality - Wireless DMX – Clean WDMX Memo.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the DMH QUAD-150 will respond to the controller.
If you set, for example, in the 23 channel mode the address to channel 24, the DMH QUAD-150 will use the
channel 24 to 46 for control.
Please, be sure that you don’t have any overlapping channels in order to control each DMH QUAD-150
correctly and independently from any other fixture on the DMX-chain.
If several DMH QUAD-150 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the DMH
QUAD-150 via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the wireless receiver is not logged in to the wireless transmitter or no wireless DMX signal is received.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
DMX-protocol
Mode/Channel Decimal Hexad. Percentage S/F
Feature
St
Ba
Ex
1
1
1
Horizontal movement (PAN) (within 630°)
0
255 00 FF 0% 100%
F
Push slider up in order to move the head horizontally
(PAN). Gradual head adjustment from one end of the
slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
2
2
2
Vertical movement (Tilt) (within 265°)
0
255 00 FF 0% 100%
F
Push slider up in order to move the head vertically
(TILT). Gradual head adjustment from one end of the
slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
3
3
3
PAN/TILT-speed
0
225 00 E1 0%
88%
F Decreasing speed
226 235 E2 EB 89% 92%
S Blackout at PAN/TILT-movement
236 245 EC F5 93% 96%
S Blackout at color/gobo-change
246 255 F6 FF 96% 100% S No function
4
4
4
Red
0
255 00 FF 0% 100%
F Red (0=off, 255=100% red)