3.
Before the boat is placed into the water for operation, make sure that the
boat power and remote control power has been turned on. In addition, the
spare battery of the remote controller should be equipped at all times to
prevent the boat from failing to return in case of no power of the remote
controller.
4. Do not make the motor idle. If the motor shaft gets away from the water level,
it cannot be cooled by water. The heat due to friction with the water seal will
make it quickly age and degrade the waterproof performance.
5. The valid distance of the remote controller signals is 400m. The valid distance
of the remote controller signals may be shortened due to influences of the
environment and other factors. Please operate the boat within the range of
visibility as much as possible during operation. When the remote control
signals are lost or the remote controller is turned off, the boat will
automatically stop in the water (the boat based on GPS automatic driving can
automatically return to the origin) and four front and rear lights will flicker
continuously at the same time. In addition, the boat and remote controller
antenna should all point to the sky, so that transmission and receiving effect
of the signals is optimal.
6. When the boat power alarm indicator is turned on, the boat can continue
navigation for about 15 minutes. When the alarm indicator starts to flicker
(GPS automatic driving boat can automatically return to the origin), please
stop operation immediately and charge the boat batteries.
7. The power indicator of the remote controller will gradually change from
green to red during use. When the power of the remote controller is low, the
power indicator will start to flicker and give out an alarm. Please replace the
