Operation
6
Touch Panel
To turn the receiver on, press the power switch on the touch panel
and release. All the LED's will come on for a few seconds. Each LED
grade display row will turn on then turn off from top to bottom. Then each
status indicator will tun on and off. The current deadband status will
momentarily display. If the receiver is out of the laser beam, the center
green LED will flash to confirm power is on. If the receiver is in a laser
beam, a corresponding LED grade display will be indicated.
To turn the receiver off, press the power switch for 2 seconds. All the
LED's will light. Releasing the switch will turn the power off.
Default Settings.
Initially, the receiver is set from the factory to the
standard deadband and dim display. Additional functions are set to
Out of Beam indication on, Laser Out of Level warning off, and Laser
Beam Averaging on.
The following sections detail the operation of each these settings.
The receiver will subsequently power on with the same settings as
when it was turned off.
Display
Brightness
Switch
Deadband
Selection
Switch
Power Switch
Low Battery
Indicator
Deadband
Indicators
Unmarked
Switch
Unmarked
Switch
Operation
Laser Beam Averaging.
The laser beam averaging
function senses the laser strikes and applies the
highest level of averaging appropriate for the laser
rotation speed. This may stabilize the LED display
if the laser set-up is unstable due to windy conditions or long range
applications.
The factory default setting is Laser Beam Averaging on.
The receiver can be set for no averaging. In this mode the receiver
processes and displays every single laser strike. To change between
the two modes, turn the receiver on. Press and hold the power switch
and then press and release the deadband switch. The outer on-grade
LED's will flash confirming the averaging function is activated. Pressing
the power / deadband switch combination again while the averaging
function is activated will toggle between on and off.
When the center LED is on, averaging is on. When the center LED is
off, averaging is off.
+
11
Averaging ON
Averaging OFF
