7
Operation
Deadband (Accuracy) Selection.
The deadband, or on-grade
accuracy, can be changed to meet various job conditions. To
identify which mode is selected, press the deadband selection
switch once. The current selection LED is activated. To change
the deadband, press the deadband selection switch again when the
deadband LED is activated. The deadband and corresponding LED will
change with each press.
Brightness Selection.
The brightness switch controls the
LED display brightness. Bright and Dim are the selection
options. Use Bright for daytime operation if necessary and
Dim for lower light conditions. Display Dim will extend battery life by
approximately 50%.
When the brightness switch is pressed and the receiver is out of the
laser beam, the LED's will display a circle with the current setting. Press
the brightness switch again while the LED's are activated to change
the setting. The LED's will then display the new setting.
When the receiver is in the laser beam, simply press the brightness
switch and the setting will change.
Fine
Deadband
~ 3/16"
(0.20"/5mm)
Standard
Deadband
~ 1/2"
(0.45"/12mm)
Wide
Deadband
1-1/4"
(1.25"/32mm)
10
Operation
Out Of Level Warning.
The Out of Level (OOL)
Warning is used with certain lasers that have the
ability to indicate they are out of level by changing
their rotation speed.
The factory default setting is Laser Out of Level Warning off.
To activate the laser OOL Warning, turn the receiver on. Press and hold
the power switch and then press and release the brightness switch.
A flashing "X" pattern indicates if the OOL Warning
is activated. If
the center green LED is not lit, the OOL Warning is off. Pressing the
power /
brightness switch combination again while the "X" pattern is
activated will turn the warning on. The center green LED will come on
to confirm the OOL Warning is on. Pressing the
power / brightness
switch combination again while the "X" pattern is activated will
toggle
between on and off.
When the warning is turned on and the laser drops to 300 RPM, a
flashing "X" will appear on the display to let the machine operator know
the laser is out of level.
Laser Out Of Level ON
Laser Out Of Level OFF
+
