Futtura LevelMaster LM5, Руководство оператора

Страница: 5 / 6

3. Weld the bar onto the unit so that both holes are vertical. (The straighter the bar is
installed the better).
4. Ensure the correct cable ends are at the control and sensor units. Carefully route the
sensor cable so the blade can swivel without stretching the cable. Tie the cable with tie
wraps (not included) so that the wire cannot be pinched.
5. Connect the sensor cable to the sensor box.
With the sensor connected the calibration can now begin for the External sensor.
External Sensor Calibration:
-First enter the initial set-up screen (see page 3) and
scroll to the sensor orientation screen. Enter the
number on the top of the sensor, which points to the
forward direction of the machines travel.
Once the sensor is oriented properly, the blade can be
calibrated.
To calibrate the blade we must exit the
initial set-­up screen and enter the menu screen.
-­Scroll thru the menu items to get to the Control axis
screen. This menu allows the user to indicate which
sensor orientation to use for their machine. There are 2
options either Cross rotation (left and right) or
Fwd/Back (front and back).
-­ Next press the menu button to move to the Zero cal
screen.
-­Lower the blade so it is resting on the ground.
-­Mark this position.
-­Press the up arrow to store this position. The screen
Should change to Zero Cal 2.
-­Turn the machine around 180 ÛDQGUHVWWKHEODGHRQ
the ground in the same location as marked previously.
-­Press the up arrow to store this position.
-­Your LM5 is now calibrated to your machine.
LM5 Wiring:
The external sensor comes complete with power and sensor cable. The sensor cable is
30’ and it has a power hook-­up, which extends 18’. The power wire has a 1 amp fuse in series to
be attached to the machines battery.
The pin outs for the control box to sensor cable is as follows:
Control box Sensor box Description
Pin 1 Pin 2 power (+12 – 30Vdc)
Pin 2 Pin 4 Can high
Pin 3 Pin 6 Can low
Pin 4 Pin 8 machine ground
Sensor 1 Forward
16.7% Next
INT
Zero Cal .1
4.1% Next
Zero Cal . 2
4.1% Next
Control axis
Cross Next
INT