23
Here are some introductions of the functions.
Upgrade Firmware
: FS28 has two firmwares. One is called BF/FW, which is the firmware of
fingerprint scanner module. The other one is called AVR/FW, which is the firmware of AVR MCU.
This function is only used for upgrade the BF/FW but not uses for upgrading AVR/FW. For
introduction of upgrade AVR/FW, please refer to the section “Upgrade AVR Firmware” on page 26.
Global Security Level
: The security level is from 0-3, the level 3 is the highest security level and
level 0 is the lowest. The higher the security level, the more detail of the fingerprint image needs to
check during identification.
Synchronize Time:
It is use to synchronized the time of PC to FS28. Note, the synchronized time
will not be shown on FS28 when it is in USB mode. The synchronized time will be shown when
FS28 leave the USB mode.
Capture
: use to capture a RAW fingerprint image.
Verify
: use for 1:1 matching, USER ID is needed to select before scanning the finger.
Identify
: use for 1:N matching.
Enroll
: use to enroll a user to FS28’s local database.
Get User
: use to send user from FS28 to PC.
Send user:
use to send user from PC to FS28
Match with log:
select it if you want to save access log when doing identification.
User Log
: use to view or get user log that store in the FS28’s local database.
Change User Type: There are two types of user. Ordinary user (1:1) matching, USER ID is needed
to select before scanning the finger. Ordinary user only can be used in USB mode. VIP user (1:N)
matching, no need to enter user ID before scanning, identification is done in whole local database of
FS28. VIP user should be registered if they have to be identified in Local mode. Ordinary users
cannot be identified in Local mode.
Please be remained that when FS28 is working in USB mode, all the Bluetooth function will be
disabled. If want to use Bluetooth function, please leave USB mode and select Bluetooth mode.
