Warning display
The function select switch
dial screen can be dis-
played from this screen.
< NO SW >
If function’s ON/OFF switch
is not selected, <NO SW>
is displayed.
89
Fu
nc
tio
n
Throttle Mode "TH MODE"
Idle-Up
"
IDLUP
"
This is a function select switch dial function. The idle up switch must be set.
This function is used to improve engine starting performance by raising the idling speed
when starting the engine of a gasoline car (boat). It is also effective when you want to
eliminate any braking effect when the power is turned off during running, due to the
effect of your gear ratio setting and choice of motor when operating an electric car.
However, considering safety, and to prevent the motor from rotating instantly when the
power was turned on, the MC950CR, MC851C, MC602C, MC402CR, and other Futaba
MC (Motor Controllers) will not enter the operation mode if the neutral position is not
confirmed. When using the MC950CR, MC851C, MC602C, MC402CR, or other Futaba
MC, confirm that the MC is in the neutral position and the set is in the operation mode
before setting the idle up function switch to ON.
The throttle neutral position is offset to the forward side. There is no linkage locking,
etc. because there is no change near the maximum operation angle even when the neu-
tral position is offset by this function.
Operation
(Preparation)
- Use the function select switch dial to select the switch.
1
(Idle-Up rate)
Select the setting item "IDLUP" using the (JOG) button. Use
the (+) and (-) buttons to set the Idle-Up rate.
2
When completed, return to the MENU screen by moving the
cursor to the positions other than SW/DIAL and pressing the
(JOG) button
Idle-Up function adjustment
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Idle-Up rate (IDLUP)
D50 ~ D1, 0, U1 ~ U50
Initial value: 0
"D": Brake side
"U": Forward side
If the power switch is
turned on while the
idle-up switch is on, an
audible alarm will be
heard. Immediately set
the Idle-Up switch to
OFF.
While this function is ON, the LED blinks.
Operation Display
The function select dial function can control the Idle-up rate with digital dial or digital
trim.
Dial / Trim Setting
