FUTABA T18MZ WC, Инструкция по эксплуатации

Страница: 123 / 178

123
＜ Model Menu (Common Functions) ＞
6HWWLQJPHWKRG
&750 PRGH
Maximum change near center by
center trim operation (Does not change at end of the
stick movement) When the adjustment range (Range)
value is made small, trim is active only near the
center.
1250 PRGH Normal trim (linear) operation.
When the adjustment range value is decreased, trim
is active only near the center. Needle high trim works
as high trim based on the center. This operation is
similar to reverse ATL trim.
1. An acceleration function can be set. This is
used when the mixture is either too rich or
too lean, which can be caused by sudden
RSHUDWLRQRIWKHWKURWWOHVWLFN
7KHUHWXUQWLPHDIWHURSHUDWLRQ'XPSFDQ
EHVHWIRUERWKVHWWLQJV$FFHOLJK
3. A needle throttle cut function can be set.
7KLVRSHUDWLRQFDQEHOLQNHGZLWKWKHWKURWWOH
hold functions (Cut and Idle), Throttle Cut
IXQFWLRQDQG,GOH'RZQ
7KHQHHGOHVLGHFXWSRVLWLRQFDQEHVHW6HWLW
to the fuel side full open position.
When MIX mode is selected, the throttle
curve setting becomes the master.
In the UNMIX
PRGHWKHWKURWWOHVWLFNSRVLWLRQ
becomes the master.
ŏ5HWXUQWR0RGHO0HQX
ŏ7RXFKWKH>)XHO0L[WXUH@EXWWRQLQWKH0RGHO0HQXWR
call the setup screen shown below.
)XHO0L[WXUH
'HGLFDWHGPL[LQJXVHGLQQHHGOHDGMXVWPHQWRIHQJLQHVZKLFKXVHDIXHO
PL[WXUHFRQWUROFDUEXUHWRU>$LUSODQHKHOLFRSWHU@
This function is dedicated mixing used in needle
adjustment of an engine that uses a fuel mixture
control carburetor.
*The needle channel is assigned to CH9 as a default.
ŏ2SHUDWLRQFXUYHVHWWLQJ
(For a description of the setting method, see the
GHVFULSWLRQDWWKHEDFNRIWKLVPDQXDO
+(/,
&237(5
$,53/$1(
*/,'(5