16
1
4
1
3
4- M3.5 × 12
Tapping screws
● Drill a hole of 2.6 mm in the four holes on the
outer side of the main gear and tighten the
tapping screws to reinforce it.
1
6
5
1
1
！ In the case of the O.S.
G T - 6 0 , 1 0 m m a b o v e
the hole position of the
marking.
If it interferes, cut this balsa.
(Fuselage inside too)
2
● In a position to
fit your engine
drill a hole with a M5
drill.
Wheel
Cut the
Silicon tube
● Fix the wheel pants with two
M2.6 x 12 tapping
screws.
M2.6 x 12 tapping screw
●
Install
the left and right
Wheels
as shown. Adjust
at the length of the
Silicon tube
so that the wheel
moves smoothly.
If Wheel pants and wheels
interfere, cut wheel pants.
●
Wheel pants
on the left and right Wheel.
Wheel shaft
Wheel stopper
Wheel nut
178 mm
●
O.S. M5 Stand-Off mount
50.8 mm（Optional）
↓ The engine is an
inverted position.
●
M 5 S c r e w
(attached to
S t a n d - O f f
mount)
● Install the engine using
O.S. M5 Stand-Off mount
50.8 mm
.
8
Installation of Engine (O.S. GT60)
● Make it about
178 mm
from
the Front frame to the drive
washer face.
●
M 5 S c r e w
(attached to
S t a n d - O f f
mount)
