5
＜
Introduction
＞
Application, Export, and Modification
1. This product is suitable for model airplane, surface or 50 MHz (license required) use, if on the correct frequency. It is
not intended for use in any application other than the control of models for hobby and recreational purposes. The prod-
uct is subject to regulations of the FCC and is restricted under United States law to such purposes.
2. Exportation precautions:
(a) When this product is exported from the country of manufacture, its use is to be approved by the laws governing the
country of destination which govern devices that emit radio frequencies. If this product is then re-exported to other coun-
tries, it may be subject to restrictions on such export. Prior approval of the appropriate government authorities may be
required. If you have purchased this product from an exporter outside your own country and not the authorized Futaba dis-
tributor in your country, please contact the seller immediately to determine if such export regulations have been met.
(b) Use of this product with other than models may be restricted by Export and Trade Control Regulations, and an appli-
cation for export approval must be submitted. In the US, use of 72MHz (aircraft only), 75MHz (ground models only) and
27MHz (both) frequency bands are strictly regulated by the FCC. This equipment must not be utilized to operate equip-
ment other than radio controlled models. Similarly, other frequencies (except 50MHz, for HAM operators) must not be
used to operate models.
3. Modification, adjustment, and replacement of parts: Futaba is not responsible for unauthorized modification, adjust-
ment, and replacement of parts on this product. Any such changes may void the warranty.
The Following Statement Applies to the Receiver (for U.S.A.)
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesirable operation.
The RBRC
™
SEAL on the nickel-cadmium battery contained in Futaba products indicates that Futaba
Corporation of America is voluntarily participating in an industry-wide program to collect and recycle these
batteries at the end of their useful lives, when taken out of service within the United States. The RBRC pro-
gram provides a convenient alternative to placing used nickel-cadmium batteries into the trash or municipal
waste system, which is illegal in most areas.
You may contact your local recycling center for information on where to return the spent battery. Please call 1-800-8-BAT-
TERY for information on battery recycling in your area. Futaba Corporation of America’s involvement in this program is
part of its commitment to protecting our environment and conserving natural resources.
RBRC is a trademark of the Rechargeable Battery Recycling Corporation.
