19
<Before Use>
Installation and Removal of the HT6F1700B
Transmitter Battery
Attachment of the battery
1. Open the battery cover on the rear of the
transmitter toward upper side.
Ɣ
Battery ribbon for
removing battery
2. Install the battery in the holder.
Ɣ
Battery ribbon
*Push the battery
until it locks
completely.
Ɣ
Connector
3. Connect the battery connector.
4. Close and lock the battery cover completely.
Battery Removal
Note: If you remove the battery while the
power is on, the data you have set will not
be saved.
1. Open the battery cover on the rear of the
transmitter toward upper side.
2. Disconnect the battery connector.
3. Pull up the battery ribbon to release the lock.
4. Remove the battery.
5. Close and lock the battery cover completely.
Warning
Be careful not to drop the battery.
Never disconnect the battery connector from
the T12FG transmitter while some message are
displayed on the screen after turning off the
power.
* Internal devices such as memories may be damaged.
* If there is any problem, the message "Backup Error" will
be shown the next time when you turn on the power of the
transmitter. Do not use the transmitter as it is. Send it to the
Futaba Service Center.
RF module MZ-FM
Ɣ0RGXOH
Ɣ&RQQHFWRU
Caution
Be sure to turn off the power of the transmitter
before you attach or detach the module.
Detachment of the RF module
Pull the module straight while you are pushing
LQZDUG RQ WKH SURMHFWLRQV RQ ERWK VLGHV RI WKH
module.
*There is a connector above and under the module
respectively. So you might find it difficult to pull out the
module if the module is tilted.
Attachment of the RF module
Insert the module with care so that the connector
pins of the transmitter won't be bent.
