FUST NOVAMATIC WA 720 E, Руководство пользователя

Страница: 14 / 52

Cancelling a programme
Turn the selector dial to to cancel a pro-
gramme which is running. Now you can se-
lect a new programme.
Opening the door after the programme
has started
First set the machine to pause by pressing
the button
7 .
If the pilot light 9 blinks and after a few mi-
nutes goes off, the door can be opened.
If the pilot light
9 remains lit, this means that
the machine is already heating or that the
water level is too high. In any case, do not
try to force the door open!
If you cannot open the door but you need
to open it, you have to switch the machine
off by turning the selector dial to
. After a
few minutes the door can be opened.
(Pay attention to the water level and
temperature!).
After closing the door, it is necessary to se-
lect the programme and options again and
to press button
7 .
At the end of the programme
The machine stops automatically. Some
acoustic signals sound and a blinking ap-
pears on the display. The pilot light of but-
ton
7 and the pilot light 9 go off.
If you have set a programme or an option
that ends with water left in the tub, the pilot
light
9 remains on. The door is locked to in-
dicate that the water must be emptied out.
During this time the drum continues to turn
at regular intervals until water draining.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 7 .
At the end of the programme, the door is
released and can be opened. Turn the pro-
gramme selector dial to
to switch the
machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
Stand by : once the programme has finish-
ed after a few minutes the energy saving
system will be enabled. The brightness of
the display is reduced. By pressing any but-
ton the appliance will come out of the ener-
gy saving status.
CARE AND CLEANING
Warning! You must disconnect the
appliance from the electricity supply,
before you can carry out any cleaning
or maintenance work.
Descaling
The water we use normally contains lime. It
is a good idea to periodically use a water
softening powder in the machine. Do this
separately from any laundry washing, and
according to the softening powder manu-
facturer's instructions. This will help to pre-
vent the formation of lime deposits.
After each wash
Leave the door open for a while. This helps
to prevent mould and stagnant smells form-
ing inside the appliance. Keeping the door
open after a wash will also help to preserve
the door seal.
Maintenance wash
With the use of low temperature washes it
is possible to get a build up of residues in-
side the drum.
We recommend that a maintenance wash
be performed on a regular basis.
To run a maintenance wash:
• The drum should be empty of laundry.
• Select the hottest cotton wash pro-
gramme.
• Use a normal measure of detergent,
must be a powder with biological proper-
ties.
External cleaning
Clean the exterior cabinet of the appliance
with soap and water only, and then dry
thoroughly.
14