FUST NOVAMATIC WA 720 E, Руководство пользователя

Страница: 12 / 52

Child safety lock
This device permits you to leave the appli-
ance unattended so you do not need to
worry that children might be injured by or
cause damage to the appliance. This func-
tion remains enabled also when the wash-
ing machine is not working.
There are two different ways to set this op-
tion:
1. Before pressing button 7 : it will be im-
possible to start the machine.
2. After pressing button 7 : it will be im-
possible to change any other pro-
gramme or option.
To enable or disable this option press si-
multaneously for about 6 seconds buttons
2 and 3 until on the display, the icon ap-
pears or disappears.
DAILY USE
Load the laundry
Open the door by carefully pulling the door
handle outwards. Place the laundry in the
drum, one item at a time, shaking them out
as much as possible. Close the door.
Make sure that no laundry stays between
the seal and the door. There is a risk of wa-
ter leakage or damage to the laundry.
Measure out the detergent and the fab-
ric softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent re-
quired, pour it into the main wash compart-
ment
or in the appropriate compartment
if the selected programme/option it requires
(see more details in «Detergent dispenser
drawer»).
If required, pour fabric softener into the
compartment marked
(the amount used
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
Select the required programme by
means of the programme selector dial
(1)
Turn the programme selector dial to the re-
quired programme.
The green pilot light of button
7 starts to
flash. The selector dial can be turned either
clockwise or anticlockwise.
Turn the selector dial to position
to reset
the programme/to switch the machine OFF.
At the end of the programme the selec-
tor dial must be turned to position
,
to switch the machine off.
Important! If you turn the programme
selector dial to another programme when
the machine is working, the red pilot light of
button
7 will blink 3 times and the
message Err is displayed to indicate a
wrong selection. The machine will not
perform the new selected programme.
Select the spin speed by pressing
button 2
When selecting a programme, the appli-
ance proposes automatically the maximum
spin speed provided for that programme.
12