Fusion ECLIPSE LX61B Pro, Руководство по эксплуатации

Страница: 6 / 16

4
Lithium Ion/polymEr/FE BAttEriEs
Lithium Ion/Polymer battery packs must NEVER be discharged below 3
volts per cell (Li-Fe 2.0V) as this will result in damage to the cells. If the
voltage is allowed to drop below 3 volts per cell the battery voltage may
seem to recover following a charge, but the battery may not then give its
full nominal capacity and a reduction in performance is likely – allowing the
voltage to drop below 3 volts per cell will invalidate all warranty claims.
NEVER charge Lithium Polymer battery packs at greater than 4.2V per
cell, Lithium Ion at 4.1V volts per cell or LiFe at greater than 3.7V per cell
as this will cause irreversible damage to the cells and will invalidate all
warranty claims.
NEVER charge Lithium battery packs above their maximum charge rate.
This can damage the pack and can be dangerous. Generally, Lithium
Polymer packs should not be charged above 1C (1 x Capacity), although
some newer packs do allow charging at 2C.
e.g Pack of 2500mAh capacity : 1C = 2500mAh = 2.5A max charge current.
DO NOT
use discharge rates in excess of those specified with the battery
pack as this will result in a significant drop in voltage under load and will
dramatically reduce the number of charge/discharge cycles the battery
pack will give.
If disposing of Lithium battery packs ensure that the pack is fully
discharged by using a light bulb, electric motor or similar to completely
discharge the pack.
DO NOT allow any Lithium battery pack to short-circuit as this is likely to
result in a minor explosion and consequent fire.
BEFORE charging any Lithium battery packs they should be closely
inspected for any damage, such as punctures in the sleeving or if the
battery has swollen or expanded in size. If any such damage is detected
DO NOT
charge, even if the battery otherwise appears to be brand new.
Before commencing charging ALWAYS double check the settings on the
charger to ensure it is set correctly for the battery pack to be charged.
Using the wrong settings is likely to result in damage to the battery pack
being charged and could result in the battery catching fire.