Furuno GP-90, Руководство по обслуживанию

Страница: 28 / 32

6. Program Upgradation
25
Steps
LED status
Insert program card into
MT-08’s slot
Initializing of MT-08
Flash memory of MT-08
is cleared
Data transfer started
Data transfer completed
Turn off MT-08 and remove
program card
Four LEDs: on
Green (left) and Yellow (right): on
Yellow (right): on
Green (light) blinking ever 2
sec (If failed, red lighting.)
Steps LED status
Connect MT-08 to GP-90.
Turn on MT-08. Four LEDs: on
Green (left) and Yellow (right):
blinking
Green (left): blinking,
Yellow (right): on
MT-08 ready to communicate
Turn on GP-90
When the communication with
MT-08 is succeeded, three beep
sounds are heard. (GP-90 goes
into
normal
function with a
signal beep.)
Data transfer started
Data transfer completed
GP-90 powered-up again
automatically.
Green (left): on,
Yellow (right): off
Green (left): on
Yellow (right): blinking
Green (light) blinking ever 2 sec
(If failed, red lighting.)
6.4 Procedure
Step 1. To transfer the data on the program card to MT-08, follow the steps below.
Necessary time: about 5 minutes
Step 2. To transfer the data from MT-08 to GP-90, follow steps below.
Necessary time: about 20 minutes