3. EQUIPMENT SETTINGS
28
Basic settings
[
Input source
]: Select the input source from [Master] and [Slave]. The default setting
is [Master].
[
ARPA QV Select
]: Set to [On] to display quantized video on the screen. Set to [Off]
for normal use.
[
Demo Mode
]: Set to [On] to active demo mode. Set to [Off] for normal use.
[
Antenna Rotation
]: [Rotate] (default setting) transmits the radar pulses by rotating
the antenna. [Stop] transmits the radar pulses without rotating the antenna.
[
Antenna Height
]: Set the height of the antenna above the water surface. The options
are 5, 10, 15, 20, 30, 40 and 50m. The default setting is 15m.
[
Near STC level
]: Set the STC curve to a near distance. The options are 1, 2, 3 and
4. “4” has the strongest effect.
[
A/C Auto Adjust
]: Adjust the performance of the automatic A/C.
[
Memory Clear
]: Restore the default settings. [Purpose], [Type] and [Source] are not
changed. When turning on the power after a memory clear, the language selection
window appears. (See page 25.)
Heading adjustment
Ensure you have installed the antenna unit correctly, so that the unit faces towards the
bow of the ship. A target at the front of the ship, aligned with the bow, must appear on
the heading line (zero degrees). If the target does not appear on the heading line, fol-
low the procedure below to adjust the heading.
1. Set the ship toward an acceptable target (for example, a ship at anchor or a buoy)
at a range between 0.125 and 0.25 nautical miles.
2. Transmit the radar at a range setting of 0.25 nautical miles and measure the bear-
ing of that target relative to the ship using an EBL.
3. Open the [Installation] menu and select [Heading Adjust].
4. Press the
ENTER
key to show the setting window for [Heading Adjust]. (See figure
below)
5. Press
S
or
T
to set the value measured in step 2. Check that the target appears
on the heading line. If necessary repeat steps 1 to 5.
6. Press
ENTER
to complete the adjustment.
Master
The display unit operates as the main radar.
Slave
The display unit operates as a remote display. For remote displays, adjust
the [Video Init Adjust] and [Timing Adjust].
(See page 30 and page 29, respectively.)
0.0°
(0.0°~359.9°)
Содержание FR-8045
Страница 41: ...30 Oct 2013 H MAKI D 1...
Страница 42: ...11 Jul 2014 H MAKI D 2 Y Hatai...
Страница 43: ...27 Nov 2013 H MAKI D 3...
Страница 44: ...27 Nov 2013 H MAKI D 4...
