Furuno FR-8045, Руководство по установке

Страница: 38 / 48

4. OPTIONAL EQUIPMENT
33
4.2 Connection of Buzzer and/or Remote Display
You will need the cables shown below to connect the optional external buzzer and re-
mote display.
• Two-way cable MJ-A10SPR
• MJ-A7SPF0007-050C
• MJ-B24LPF0010-xxx+R (000: 100, 200, or 300)
External buzzer
When a target enters, or exits, in the target zone, the optional external buzzer gives a
loud alarm.
Attach the two-way cable and MJ-A7SPF0007-050C cable to the OPTION port at the
rear of the display unit. See the above figure.
1. Cut the NH connector at the end of the external buzzer cable to an acceptable
length.
2. Solder the external buzzer cable to the MJ-A7SPF0007-050C cable as shown be-
low. Before you solder the cores, cut the heat-shrink-tube in half and set the tubes
to the cores of the cable. Solder the cores, then set the tubes on the soldered
point.
3. Fasten the buzzer with the double-sided tape or two self-tapping screws (3x15 or
3x20, local supply).
Type OP03-21
Code No. 000-030-097
Name Type Code No. Qty Comment
Buzzer PKB42SWH2940 000-153-221-10 1 One NH connector attached
Cable tie CV-70N 000-162-185-10 4
Heat-shrink-tube 3x0.25 BLK 000-165-283-10 1 40 mm
Double-sided tape 9760 000-800-851-00 1 25 mm × 25 mm
OPTION
Remote Display
External buzzer
MJ-A7SPF0007-050C (5 m)
MJ-10P
MJ-10P MJ-7P
MJB24P
Display unit
RDP-154
Connection Port
MJ-A10SR * (0.2 m)
MJ-B24LPF0010-xxx+R (10/20/30 m)
(xxx: 100, 200 or 300)
*: This cable is not required to connect the remote display only.
Red
Black
External buzzer
MJ-A7SPF0007-050C
Solder
Cut other cables off, and wrap here with tape.