Furuno FR-2135S, Руководство по установке

Страница: 12 / 82

1-4
Scanner unit assembling
The scanner radiator and the scanner housing are shipped in separate packages.
Assemble them as below. The scanner unit may be assembled before hoisting it to
the mounting platform. However, do not lift the scanner unit by the radiator.
Scanner unit assembling procedure
1. Screw the guide pins (2 pcs.) in the radiator.
2. Remove the protective cap from the choke guide.
3. Grease O-ring and set it to groove of the choke guide.
4. Place the radiator on the radiator bracket. (Radiator direction is shown by the
logo on the bracket. If reversely oriented the radiator cannot be set to the bracket.)
5. Loosely fix the radiator to the radiator bracket with hex bolts (M10 x 25), spring
washers and flat washers.
6. Remove the guides pins and tighten hexagon bolts.
Scanner radiator
Do not remove the teflon tube from
the center conductor.
Guide pin (2 pcs.)
Instruction label for scanner
aperature direction
Protective cap
Radiator bracket
Choke guide
O-ring
(JIS B2401-
1A-G60, 2 pcs.)
Spring washer,
flat washer,
10 pcs. each,
M10
x
25
Figure 1-4 Assembling the radiator
CAUTION
Be sure to remove the guide pins.
Injury may result if the guide pins loosen
and fall.