Furuno FEA-2107, Руководство по установке

Страница: 13 / 168

1. MOUNTING
1-5
1.2 Control Unit
The control unit may be mounted on a desktop, with or without the KB fixing metal
(supplied), which mounts the control unit at an angle.
Mounting considerations
When selecting a mounting location, keep in mind the following points:
•
Select a location where the control unit can be operated conveniently.
•
Locate the unit away from heat sources because of heat that can build up inside the
cabinet.
•
Locate the equipment away from places subject to water splash and rain.
•
Determine the mounting location considering the length of the signal cable between the
control unit and the processor unit. (The length of the signal cable is 10/20/30 m).
•
A magnetic compass will be affected if the control unit is placed too close to the magnetic
compass. Observe the compass safe distances on page ii to prevent deviation of a
magnetic compass.
Fixing without KB fixing plate
1. Fix the KB fixing plate to the rear panel of the control unit.
2. Attach cushions (three for RCU-018, two for RCU-015FEA) to the bottom of the control
unit as shown below.
3. Fix it to a desired location with self-tapping screws.
Cushion
KB fixing plate
RCU-018/0RCU-15FEA, side view