Furuno FCV-587, Руководство оператора

Страница: 50 / 83

4. INSTALLATION
43
2°-10° transom angle (stepped tran-
som and jet boats)
: Position the shim
with the tapered end down.
19°-22° transom angle (small alumi-
num and fiberglass boats)
: Position the
shim with the tapered end up.
Sensor position and transom angle
3. If the bracket has been temporarily fas-
tened to the transom, remove it. Apply a
marine sealant to the threads of the three
#10 x 1-1/4" self tapping screws to pre-
vent water seeping into the transom.
Screw the bracket to the hull. Do not tight-
en the screws completely at this time.
4. Repeat step 1 to ensure that the angle of
the sensor is correct.
Note: Do not position the sensor farther
into the water than necessary to avoid in-
creasing drag, spray, and water noise
and reducing boat speed.
5. Using the vertical adjustment space on
the bracket slots, slide the sensor up or
down to provide a projection of 3 mm
(1/8"). Tighten the screws.
Vertical adjustment and cable routing
Attaching the sensor to the bracket
1. If the retaining cover near the top of the
bracket is closed, open it by depressing
the latch and rotating the cover down-
ward.
Attaching the sensor to the bracket
2. Insert the sensor's pivot arms into the
slots near the top of the bracket.
3. Maintain pressure until the pivot arms
click into place.
4. Rotate the sensor downward until the bot-
tom snaps into the bracket.
5. Close the retaining cover to prevent the
accidental release of the sensor when the
boat is underway.
2 º- 10 º
transom
angle
11 º transom angle
NO SHIM
19 º -22 º
transom
angle
shim with
taper down shim with
taper up
YES
YES
YES
parallel parallel
parallel
12 º -18 º transom angle
NO SHIM
NO NO
YES
angle
reversed
slight
angle
angle too
steep
Cable cover
Cable
clamp
50 mm (2")
Hull projection 3 mm (1/8")
Step 1 Step 2
Step 3
Step 4
Latch
Pivot
arm (2)
Slot (2)
Retaining
cover