Furuno FCV-587, Руководство оператора

Страница: 48 / 83

4. INSTALLATION
41
4.6 Triducer
DO NOT overtighten screws. They may be
damaged.
525T-BSD, 526TID-HDD
For details of the installation, see the manual
of the triducer.
525STID-MSD
The optional triducer 525STID-MSD is de-
signed for thru-hull mounting. For how to in-
stall this triducer see section 4.3.
Triducer 525STID-MSD
525T-PWD
For details of the installation, see the manual
of the triducer.
525STID-PWD
The optional transom mount triducer
525STID-PWD can be installed by the thru-
hull method or the inside-hull method.
Pre-test for speed and temperature
Connect the sensor to the instrument and spin
the paddlewheel. Check for a speed reading
and the approximate air temperature. If there
is no reading, return the sensor to your place
of purchase.
Tools and materials needed
Mounting location
To ensure the best performance, the sensor
must be submerged in aeration-free and tur-
bulence-free water. Mount the sensor close to
the centerline of the boat. On slower heavier
displacement hulls, positioning it farther from
the centerline is acceptable.
Allow adequate space above the bracket for it
to release and rotate the sensor upward.
Note 1: Do not mount the sensor in an area of
turbulence or bubbles: near water intake or
discharge openings; behind strakes, struts,
fittings, or hull irregularities; behind eroding
paint (an indication of turbulence).
Note 2: Avoid mounting the sensor where the
boat may be supported during trailering,
launching, hauling, and storage.
φ
79
133 2.00"-12 UN
threads
φ
51
7
27 140
Unit: mm
BOW
• Scissors • Masking tape
• Safety goggles • Dust mask
• Electric drill • Screwdrivers
• Drill bit:
For bracket holes: 4 mm, #23, or 9/64"
For fiberglass hull: chamfer bit (preferred),
6 mm, or 1/4"
For transom hole: 9 mm or 3/4" (optional)
For cable clamp holes: 3 mm or 1/8"
• Straight edge • Marine sealant
• Pencil • Cable ties
• Water-based antifouling paint (mandatory in
salt water)
Height
Height without
speed sensor
191 mm (7-1/2")
Height with
speed sensor
213 mm (8-1/2")