Furuno FAR-3230SW-BB, Руководство по установке

Страница: 19 / 169

1. INSTALLATION
1-5
1. Construct a suitable mounting platform referring to the outline drawing at the end
of this manual.
2. Referring to the outline drawing, drill four mounting holes in the mounting platform.
3. Place the antenna unit on the platform, then orient the unit so the bow mark on its
base is facing the ship’s bow.
4. Fasten the antenna unit to the mounting platform with four sets of M12
×
60 hex
bolts, nuts, flat washers, seal washers and spring washers. Insert the bolts from
the topside of the platform. The torque must be 49 N•m.
Insert the bolts from the
top of the platform. DO NOT insert the bolts from the underside of the plat-
form. The cover cannot be opened
.
5. Using a hex bolt (M6
×
25), nut (M6) and flat washer (M6), establish the ground sys-
tem on the mounting platform as shown in the figure on the next page. The loca-
tion must be within 340 mm of the ground terminal on the antenna unit. Connect
the ground wire (RW-4747, 340 mm, supplied) between the grounding point and
ground terminal on the antenna unit. Coat the hardware of the ground system with
marine sealant (supplied).
Bow mark ( )
FRONT FRONT