Furuno FAR-3230SW-BB, Руководство по установке

Страница: 44 / 169

2. WIRING
2-8
6. DE-ICER INSTALLATION . See also “X-band De-icer Kit Installation Instructions”,
issued separately, for the de-icer not fitted at the factory. If the de-icer is not pro-
vided, go to step 7.
1) Set a locking wire saddle (supplied at locations (2) and (3) shown below. Pass
the power cable through the locking wire saddles (1) through (3) and pull it to
the front side.
2) Unfasten the cable band*. Pass the
power cable for the de-icer through
the band then fasten the band. Con-
nect the cable to TB901 on the DE-
ICER board (03P9573), using the
crimp-on lugs supplied.
* For the DE-ICER installation kit, un-
fasten the cable band on the cover
supplied. (The original cover can be
discarded.).
3) Set the voltage setting switch accord-
ing to the power source for the de-ic-
er; 115 V or 230 V. The default setting
is 230 V.
4) Apply power to the de-icer then press the [TEST] button on the DE-ICER board
approx. ten seconds. Check that the heater gets hot.
Front cover, inside view
DEICER Board
(03P9573)
DE-ICER Board (03P9573)
Voltage Selection switch
[TEST] button [TEST] button
TB901 TB901
DE-ICER board
(03P9573)
TB901
Cable band Cable band
[TEST]
button
[TEST]
button
Voltage
Selection
switch
Voltage
Selection
switch