Furuno FAR 3220, Руководство по установке

Страница: 55 / 245

2. WIRING
2-13
11. Coat the hinge with the supplied adhesive to waterproof the hinge then close the
cable entrance cover. Fix the cable cover with four screws, then coat the screws
with the supplied adhesive.
12. Reconnect the performance monitor connector (J807) to the rear cover.
13. Hold the rear cover at the lower part (near
the intake), and the push it horizontally to-
wards the chassis until the gasket between
the front and rear covers are about 5 mm
wide. Then close the rear cover with four
bolts. The torque for the fixing bolts must be
10.0 N•m.
Note 1: After pushing the rear cover by
hand, check that the gasket width is approx.
5 mm at three places (the top, middle, and
bottom) of the gasket.
Note 2: For the de-icer, take care not to hit the heater elements on the chassis or
radiator when the front cover is being attached or detached.
• To fix the heater elements, close the open heater to return it to its original posi-
tion, then unfasten the fixing screws for the heater to adjust the position of the
heater.
• If it is necessary to open the front cover after installing the de-icer kit, remove
the de-icer power cable from the locking wire saddle as shown in the following
figure, then detach the cover slowly to prevent damage to the heater element.
Adhesive
Close
Cable entrance cover
Adhesive
Screw
Gasket width
approx. 5 mm
FRONT FRONT
Remove the power cable from the locking wire
saddle to open the front cover.
Remove the power cable from the locking wire
saddle to open the front cover.