Furuno FAR 3220, Руководство по установке

Страница: 53 / 245

2. WIRING
2-11
9. For DE-ICER INSTALLATION , connect the de-icer power cable to the de-icer
board 03P9573 attached on the front cover. If the de-icer is not provided, go to
step 10.
1) Remove four screws from the motor and
disconnect connectors J875 and J876 to
remove the motor.
2) Set a locking wire saddle (supplied) at locations (B) and (C) shown in the fol-
lowing figure. Pass the de-icer power cable from cable entrance through the
locking wire saddles (A), (B) and (C) and pull it to the front side.
TB803
Signal line
C
B
A
Coaxial cable
TB804
Fasten shield
with clamp. Fasten conductor
with screw.
B
REAR REAR
NOTE: Do not use
crimp-on lug, to prevent
contact resistance from
increasing.
Front cover w/de-icer,
inside view
DEICER Board (03P9573)
TB901
Voltage Setting
switch
[TEST] switch
J876
J875
Motor Motor
Remove the motor.
Four
screws
FRONT FRONT
A
B
B
C
C