Furuno DRS4DL+, Руководство по установке

Страница: 9 / 32

1. INSTALLATION
3
Tools and materials for mounting
Installation on a platform
Follow the instructions below to install the sensor on a platform.
Note: On the bolt and washers,
• DO NOT detach the hex bolts and flat washers until the installation.
• DO NOT turn the radome upside down after detaching the hex bolts and flat wash-
ers.
• If the radome is put upside down with only the small flat washer and hex bolt in
place, the hex bolt and flat washer may protrude into the radome and damage the
RT unit.
Name Usage
Electric drill Drill holes for mounting. Drill bit:
I
11 mm
Hexagonal wrench Fastening bolts: Diagonal: 6 mm
Self-vulcanizing tape For water proofing of connector junction.
Vinyl tape
Cable tie
For tying up the cable.
Marine sealant For coating exposed parts of bolts.
STERN
BOW
Align bow mark (Δ)
on antenna with
boat’s centerline.
Power/LAN cable (1.4 m)
Drill holes referring to the outline drawing
and the mounting template.
Mounting platform
Hex bolt (M10 × **)
Spring washer
Flat washer
Flat washer (M12), top in order
For transportation, not for the
installation.
Flat washer (M10),
middle in order
Spring washer (large),
last in order.
Default orientation of
bolt and flat washer
**: Bolt length.
See table on next page
for details.