Furuno DRS4DL, Инструкция по установке

Страница: 13 / 28

2. WIRING
8
Turning the power on and initial setup
Use the information in this manual and the manual for TZTL12F/TZTL15F/TZT9/
TZT14/TZTBB* to power the sensor and to proceed with initial setup.
* Hereafter these units are referred to as “multi function display device”.
1. Press and hold down the power key of your multi function display device until the
unit is ON. The magnetron warm-up sequence starts. When the warm-up se-
quence is completed, the unit goes into the standby mode.
2. Take the appropriate action on your multi function display device to turn on the
DRS4DL.
3. If necessary, adjust the brightness and change the language on the multi function
display device.
4. Ensure that all personnel are clear of antenna.
5. Check if the heading is correctly aligned - targets should appear at their correct
bearing relative to the boat’s bow. Adjust the alignment if necessary, referring to
installation manual of your multi function display device.
6. Check the display timing, referring to installation manual of your multi function dis-
play device.
WARNING
The radar antenna emits electro-
magnetic radio frequency (RF)
energy, which can be harmful to the
human body and interfere with pace-
maker function. Never look directly
into the antenna aperture and keep
at least 1.1 m away from the radar
antenna while the radar is in operation.