Furuno DRS4DL, Инструкция по установке

Страница: 10 / 28

1. INSTALLATION
5
• The cable must be fixed so no tension is applied to the connectors. To prevent
tension, create a loop in the cable close to the sensor and tie the loop with cable
ties, as in the figure below.
• Wrap the junction of the connectors with self-vulcanizing tape for waterproofing.
• Fasten the cable to the mast, etc. at the neck of each connector with a cable tie.
6. Connect the power/LAN cable to the power source and display unit.
Installation with the radome mount
The optional radome mount lets you fasten the radar sensor to a mast on a sailboat.
Name, Type : Radome Mount, OP03-209
Code No. : 001-078-350
How to assemble the bracket
1. Fasten the fixing plates to brackets (1) and (2) with four M8
u
20 hex bolts.
2. Fit brackets (1) and (2) loosely with support plates (1) and (2) using four M4
u
12
hex bolts, so that the gap between the brackets can be adjusted.
3. Place the mounting plate on the bracket and fix it loosely with four M8
u
20 hex
bolts.
Name Type Code No. Qty
Mounting plate 03-018-9001-0 100-206-740-10 1
Support plate (1) 03-018-9005-0 100-206-780-10 1
Support plate (2) 03-018-9006-0 100-206-790-10 1
Bracket (1) 03-028-9101-1 100-206-811-10 1
Bracket (2) 03-028-9101-2 100-206-812-10 1
Fixing plate 03-028-9103-1 100-206-831-10 2
Hex bolt w/washer M8
u
20 SUS304 000-162-955-10 8
Hex bolt w/washer M4
u
12 SUS304 000-162-956-10 4
Loop cable and tie loop with cable ties.
The minimum bend diameter is 80 mm.
Wrap junction with self-vulcanizing tape
Connect cables