Furuno CI-88, Руководство по установке

Страница: 36 / 83

4. ADJUSTMENT
4-2
NMEA VERSION
Choose NMEA version of sentences which are output from the NMEA 1 port and
NMEA2/CIF port. The choices are NMEA 1.5, 2.0 and 3.0, and IEC61162. The input
sentences do not require NMEA version.
NMEA PORT 1 BAUD RATE
Choose baud rate of equipment connected to NMEA 1 port. The choices are 4800 and
38400 (bps).
NMEA2/CIF FORMAT
Choose format of equipment connected to NMEA2/CIF port. The choices are NMEA and
CIF.
When selecting “NMEA” here, the sentences are output with the NMEA version selected ar
NMEA VERSION. The baud rate is fixed to 4800 bps. To choose “CIF”, set the jumper
switch J4 on the PCN Board (66P3924) to CIF.
NAV SOURCE
Choose source of nav data among AUTO, GPS and LORAN-C. AUTO reads position data
in order of accuracy: GPS>LC.
NAV DATA
Choose source data for calculation of sea tide in the NAV mode.
SPD: Speed data from the GPS navigator is used as ground tracking speed to calculate
sea tide.
L/L: Position data from the GPS navigator is used as ground tracking speed to calculate
sea tide.
TIME INTERVAL
Set the time interval for reading position data to use for calculating speed. Effective when
NAV DATA above is selected to “L/L.” The choices are 1, 2, 3 and 4 (min).
HEADING DEVICE
Choose YES if a heading device is connected to the current indicator. When “YES” is
selected, you can choose NU or HU on the DISP1 menu. For selection of “NO”, the display
mode is fixed to HU.
FORMAT
When “YES” is selected at HEADING DEVICE above, choose the format of the heading
device which is connected to the current indicator. The choices are AD-10 and NMEA.
HDG OUT <0.5kn
Choose type of bearing to output when ship’s speed is higher than 0.5 kn. The choices are
COG (Course Over Ground) and HEADING.