Copyright © 2017 Funtronix LLC. All rights reserved
6
SECTION 2: USING YOUR CLOCK/TIMER
1.
Press and hold the
button for approximately 3 seconds to reset the current
timer mode. The timer’s display will flash the currently-selected program mode for
several seconds (Pr mode). While the program mode is flashing, each press and
release of the
button will cycle the clock/timer through its different modes
of operation. Once the program mode stops flashing, the timer is locked into the
selected mode.
You must first stop the clock by pressing and releasing the
button
.
Your T-240/T-260 event timer has 6 different modes of operation. The modes are
defined in the tables below:
T-240 4-Digit Event Timer Modes:
Operating Mode
Description
Pr 1
Count-down clock with display format MM:SS, where “MM”
is minutes and “SS” is seconds
Pr 2
Count-up timer with display format MM:SS, where “MM” is
minutes and “SS” is seconds
Pr 3
Count-down clock with display format HH:MM, where “HH”
is hours and “MM” is minutes
Pr 4
Count-up timer with display format HH:MM, where “HH” is
hours and “MM” is minutes
Pr 5
Count-down >> Count up, with display format MM:SS,
where “MM” is minutes and “SS” is seconds
Pr 6
Count-down >> Count up, with display format HH:MM,
where “HH” is hours and “MM” is minutes
T-260 6-Digit Event Timer Modes:
Operating Mode
Description
Pr 1
Count-down clock with display format MM:SS:hh, where
“MM” is minutes, “SS” is seconds, and “hh” is hundredths
of seconds
Pr 2
Count-up timer, with display format MM:SS:hh, where “MM”
is minutes, “SS” is seconds, and “hh” is hundredths of
seconds
Pr 3
Count-down clock with display format HH:MM:SS, where
“HH” is hours, “MM” is minutes, and “SS” is seconds
Pr 4
Count-up timer with display format HH:MM:SS, where “HH”
is hours, “MM” is minutes, and “SS” is seconds
Pr 5
Count-down >> Count-up, with display format MM:SS:hh,
where “MM” is minutes, “SS” is seconds, and “hh” is
hundredths of seconds
Pr 6
Count-down >> Count-up, with display format HH:MM:SS,
where “HH” is hours, “MM” is minutes, and “SS” is seconds
2.
If the count down clock is used (PR 1, 3, 5, or 6), set the length of the count down
time using the
and
buttons.
