Funkwerk FAC 9400 IP, Руководство по эксплуатации и установке, Страница: 28 / 33

FAC 9400 IP accessories
CD with Active X
(Software to display video images on a computer monitor) Order no. 943526110100
Commissioning/configuration
The FAC 9400 IP camera may be used only with a suitable PSU (12 V DC to 29 V DC, ≥15 W).
All setting processes during commissioning and service will be carried out exclusively via the control interface
(LAN-PGE) or a web browser while the device is closed. The device may be opened only in the factory by
trained and authorized persons as otherwise long-term damage and a failure of the cooling system are to be
expected!
With other configuration steps, it will be assumed that the FAC 9400 IP camera is in delivery state.
Delivery state:
All necessary data is available on the web site. The default IP address is 192.168.128.2.
Necessary accessories for initial commissioning/configuration
Cross-over LAN cable to PC (or HUB + 3 LAN cables).
Suitable power supply.
Commissioning and configuration of the FAC 9400 IP camera
Note
The subsequent configuration allows the transmission of a video signal via LAN from FAC 9400 IP to a digital
receiving unit (e.g. PC "Lifeimage "). The video quality is PAL FULL D1. Please set only the parameters of the
following description. If you deviate from the following description, function will not be guaranteed. Please also
note that the images shown in the following depend in part on the version of your operating system and may
therefore differ.
Setting the IP address of the FAC 9400 IP camera
Connect the LAN connection of the FAC 9400 IP camera with a "crossover cable" (available at computer stores)
with crossed sending-receiving lines to the computer Ethernet connection. (The connection of computer with
FAC 9400 IP with non-crossed standard LAN cables is possible with the interface circuit of a hub/switch.) Keep
in mind here that the bandwidth of the network allows at least 4Mbit/S with a sufficiently large reserve, as
otherwise access to the web server will no longer be possible with activated transmission.
Now switch on the FAC 9400 IP camera (e.g. by putting in a suitable PSU).
The connection between computer and FAC 9400 IP is established with the help of the Internet browser that is
installed on the computer.
Internet browser and FAC 9400 IP camera must be connected via the current IP address of the FAC 9400 IP
camera before you can change the IP address of the FAC 9400 IP camera; the default IP address for new
devices is
192.168.128.2 . and the subnet mask is 255.255.255.0 . If the IP address of the FAC 9400 IP camera
is not available, then the FAC 9400 IP camera can be set to the default address at any time as described in the
section "Delivery state". The subsequent description uses the FAC 9400 IP camera default IP address.
Note: A connection between PC and FAC 9400 IP camera is possible only if the computer's network setting
matches the FAC-9400-IP-camera's IP address class and the subnet mask used. A computer with Windows XP
is assumed for any additional settings.
FAC 9400
01/2013
28